Listed Building

The only legal part of the listing under the Planning (Listing Buildings and Conservation Areas) (Scotland) Act 1997 is the address/name of site. Addresses and building names may have changed since the date of listing – see 'About Listed Buildings' below for more information. The further details below the 'Address/Name of Site' are provided for information purposes only.

Address/Name of Site

KIRNIE LAW RESERVOIR AND SURGE TOWERLB49126

Status: Designated

Documents

There are no additional online documents for this record.

Summary

Category
B
Date Added
10/03/2003
Local Authority
Scottish Borders
Planning Authority
Scottish Borders
Parish
Innerleithen
NGR
NT 34841 38691
Coordinates
334841, 638691

Description

Boving & Co, London (hydraulic engineers), Melville Dundas and Whitson (contractors) and J Sharp (consulting engineer) for Henry Ballantyne and Sons, Limited; started 1919 - operational 1922. Free standing, square-plan reservoir with subterranean 12in. cast-iron pipe leading to tall square-plan tower containing surge tank. Ferro-concrete with cast-iron pipes, all steel riveted.

RESERVOIR: square-plan, ferro-concrete reservoir with tapered side walls (8 in. thick at top tapering to 14 in. in the upper 10 ft. 6 in before broadening to 21 in. at base) with reinforced concrete base. SE elevation formerly with advanced concrete lettering reading HENRY BALLANTYNE AND SONS, LTD KIRNIE LAW RESERVOIR (hole now blown through centre); overflow/sluice ramp to left of lettering; to far left, iron ladder leading to concrete viewing platform to top of angle (further ladder on other side leading down into reservoir). All other elevations plain except for a projecting concrete lean-to (which housed electrical recording appliances connected with the Barograph Recorder in the mill and showed, amongst other things, height of water in reservoir) at S angle and the outlet and inlet valve.

INTERIOR: 192 feet square by 15 ft. 6 in. deep reservoir. 9 in. thick concrete floor slab (light reinforcement near upper surface) increasing to 18 in. thick approximately 6 ft. from inner face of walls; floor slab continues to form 2 ft. thick toe to exterior of wall (slab 21 in. thick under wall to 9 in. thick at outer point). Side walls heavily reinforced and tied to floor slab and given a fine plaster finish.

SURGE TANK: tall square-plan ferro-concrete tower with projecting angle margins encasing surge tank; 9 inch steel riveted high pressure pipeline set within ground to front with pair of access man-holes with cast-iron covers (one now missing), lesser pipe adjacent to left.

Statement of Special Interest

Kirnie Law reservoir sits in a saddle between the hills of Kirnie Law (1541 ft.) and Priesthope Hill (1802 ft.), 1000ft. above the mills it served and on the lip of the Walker Burn. The Ballantyne family owned Tweedvale Mill in Walkerburn since its construction in the mid-19th century. A rival mill, Tweedholm (also in Walkerburn) was bought by them in 1918 and it was decided a more efficient means of producing power for both mills was needed. Until then, power was supplied by water in the shared mill lade fed from the River Tweed and used to turn breast wheels. Combined, the power derived from these sources was around 110 horse-power. It was necessary to produce 450 horse-power for the mills' requirements. Bovey and Co, Ltd. (56 Kingsway, London) were consulted and came up with a scheme that relied on the mechanical storage of power; that is storing surplus energy when it was not needed. A reservoir sited high on the hills would be capable of holding 3,500,000 gallons of water when full and took 132 hours to fill from empty. Water flowed down the hill via the high-pressure pipeline when needed and fed a pelton turbine, which had its own generator and produced an additional 230 horse-power. This power when added to the power produced by the low-pressure turbines gave the necessary horse-power for the whole factory complex. At night (when the mill was not in operation), surplus power was used to pump water back up the hill into the reservoir. To achieve this, the belts coupling the low-pressure turbines were moved across to the pump pulleys and the pumps started to return the water up the hill. All the concrete used during the construction of the reservoir and tower was prepared on site and was hauled up the hill by means of a purpose built funicular railway. 400 tons of cement, 100 tons of reinforcing bars and over 3000 tons of aggregate was used for the construction. The total weight the railway pulled up was estimated at approximately 3,650 tons. During construction, the reinforced side walls were tied into the floor and any local strain is borne by the construction as a whole; it was not rigid but yielded gradually to the pressure of the water when full. A 12in.water pipe leads from the reservoir and follows the contour of the hill until it meets the tower. This tower houses a surge tank, which was big enough to compensate for sudden variations in the water demand. It is also here the pipe changes to a 9in. diameter one (again subterranean). It continues its journey down the hill to the mill lade. All the pipe work is steel riveted with great care taken on joint flanges. The scheme was a success and was used to supply power to the mill for over 25 years. The mill eventually became hooked up to the National Grid and its hydro-electric scheme became obsolete. With the reservoir no longer being used, a hole was blown in the side of it to prevent it from overflowing or potentially giving way and flooding the village and valley below, as well as preventing potential drowning accidents. Unfortunately, the hole is where the name of the reservoir used to be. The reservoir is listed due to its importance as the water storage for Scotland's first pumped storage hydroelectric scheme. It is also a testament to the engineers and workers who carried out the construction of such a groundbreaking scheme on difficult terrain.

References

Bibliography

Henry Ballantyne and Sons, Limited & Boving & Co, London, THE EVOLUTION OF A WATER POWER SCHEME: 1854-1921 detailing powering of Tweedvale and Tweedholm mills, Walkerburn. J Buchan, HISTORY OF PEEBLESSHIRE (1925) pp221-222. WORLD ENGINEERING, VOL II (date unknown), pp1489-1491. THE SCOTSMAN (Fri, 15th Oct, 1965) for article on Kirnie Law Reservoir. FW Pearce, WALKERBURN, ITS ORIGINS AND PROGRESS, 1854-1987 (1987) pp10-15. NMRS, PEEBLESSHIRE ARCHIVE BOX, W - Walkerburn for photos of scheme.

About Listed Buildings

Historic Environment Scotland is responsible for designating sites and places at the national level. These designations are Scheduled monuments, Listed buildings, Inventory of gardens and designed landscapes and Inventory of historic battlefields.

We make recommendations to the Scottish Government about historic marine protected areas, and the Scottish Ministers decide whether to designate.

Listing is the process that identifies, designates and provides statutory protection for buildings of special architectural or historic interest as set out in the Planning (Listed Buildings and Conservation Areas) (Scotland) Act 1997.

We list buildings which are found to be of special architectural or historic interest using the selection guidance published in Designation Policy and Selection Guidance (2019)

Listed building records provide an indication of the special architectural or historic interest of the listed building which has been identified by its statutory address. The description and additional information provided are supplementary and have no legal weight.

These records are not definitive historical accounts or a complete description of the building(s). If part of a building is not described it does not mean it is not listed. The format of the listed building record has changed over time. Earlier records may be brief and some information will not have been recorded.

The legal part of the listing is the address/name of site which is known as the statutory address. Other than the name or address of a listed building, further details are provided for information purposes only. Historic Environment Scotland does not accept any liability for any loss or damage suffered as a consequence of inaccuracies in the information provided. Addresses and building names may have changed since the date of listing. Even if a number or name is missing from a listing address it will still be listed. Listing covers both the exterior and the interior and any object or structure fixed to the building. Listing also applies to buildings or structures not physically attached but which are part of the curtilage (or land) of the listed building as long as they were erected before 1 July 1948.

While Historic Environment Scotland is responsible for designating listed buildings, the planning authority is responsible for determining what is covered by the listing, including what is listed through curtilage. However, for listed buildings designated or for listings amended from 1 October 2015, legal exclusions to the listing may apply.

If part of a building is not listed, it will say that it is excluded in the statutory address and in the statement of special interest in the listed building record. The statement will use the word 'excluding' and quote the relevant section of the 1997 Act. Some earlier listed building records may use the word 'excluding', but if the Act is not quoted, the record has not been revised to reflect subsequent legislation.

Listed building consent is required for changes to a listed building which affect its character as a building of special architectural or historic interest. The relevant planning authority is the point of contact for applications for listed building consent.

Find out more about listing and our other designations at www.historicenvironment.scot/advice-and-support. You can contact us on 0131 668 8914 or at designations@hes.scot.

Images

There are no images available for this record, you may want to check Canmore for images relating to KIRNIE LAW RESERVOIR AND SURGE TOWER

There are no images available for this record.

Search Canmore

Printed: 14/05/2024 20:44